After a swarm leaves: what to check
Last updated
After the cluster flies off, check whether scouts moved into a wall, and close the cavities honey bees actually use before the next swarm follows the wax smell.
The quiet after a swarm lifts off does not automatically mean the problem is over. Scout bees may already have chosen a gap in the soffit. The branch they hung on can hold a smear of wax that makes the same spot interesting to the next cluster. And a colony that has vanished from the limb may now be inside the wall, which is a worse outcome than the afternoon you spent watching it.
This page covers what to inspect after an exposed cluster leaves. It is not instructions for opening a wall. If bees are already flying in and out of the house, go to Bees in a wall, roof or chimney.
Confirm they left, instead of moving in
University of California IPM describes the moment people misread. A cluster on the side of a building may be resting, or it may be filing one by one through a hole. If the cluster is shrinking and has not flown away as a cloud, the bees are likely moving into the cavity. At that stage they are short on food, building comb from honey they carried, and they still have to forage outside. You can hear a low hum once they are in. (ipm.ucanr.edu)
A real departure looks different. The mass goes airborne together. UC IPM says scouts guide that flight, and at the new entrance the bees cluster and fan, releasing a scent that pulls the rest inside. If you watched the ball break up and disappear over the neighbor's roof, the stopover is over. If you came home and the branch was simply empty, you do not yet know which version happened. Walk the walls before you call it done.
University of Georgia Extension gives a confirming sign for a colony that has settled, in Circular 824 by Keith S. Delaplane (revised July 24, 2024): bees flying back and forth from a gap, and bees returning with yellow pollen on their legs. Pollen means they are feeding larvae. That is no longer a swarm in transit. (fieldreport.caes.uga.edu)
Clemson University's HGIC 1736 is just as plain about the consequence. Once bees are in a chimney, a column, or a wall, they are not swarming anymore. They will draw comb, lay eggs, and store honey and pollen. Sealing the hole, or killing them and leaving the nest, leaves wax and honey to rot and attract rodents and other pests. The comb has to come out before the entrance is closed. Some beekeepers can open the cavity. The carpentry afterward is a contractor's job. (hgic.clemson.edu)
What they leave on the branch
UC IPM notes that a resting swarm usually leaves a bit of beeswax where it clustered, and further swarms can be expected at that same spot. That wax is not just residue. Honey bees can smell it. After a colony is cut out of a building, UC IPM says the odor of beeswax remains noticeable from a long distance and stays attractive to later scouts. The same logic applies, on a smaller scale, to the smear on a limb, a fence cap, or the corner of a gutter where this cluster parked. Wiping the spot does not hurt. It also does not replace closing the cavities those scouts were measuring. (ipm.ucanr.edu)
Penn State Extension makes the attraction specific: honey bees are particularly drawn to spaces other honey bees have already occupied. If this swarm was interested in your eaves, the next one may be too, especially if a previous colony left comb or propolis behind. Mississippi State says the odors of residual comb and propolis draw new swarms, which is why a house can end up with more than one colony in different cavities, some of them offspring of a nest that was never removed. (extension.psu.edu)
The cavities they are actually measuring
UC IPM, citing nest-selection research including Thomas Seeley's 1977 work on how bees measure cavity volume, states the preferences in homeowner units. Honey bees will use a cavity of at least about 4 gallons. They prefer something around 9 gallons. They prefer it dark, with an entrance that is easy to defend and at least about 9 feet off the ground. A hollow tree fits. So do wall voids, chimneys, outbuildings, fence posts, shrubs, water meters, utility boxes, barbecue grills, soffits, and the space under a deck. (ipm.ucanr.edu)
Mississippi State puts a number on the hole, which is more useful than "seal everything." Bees prefer an entrance several inches across and will use an opening as small as one-fourth of an inch. The authors' prevention list, written for the walk you should have done before swarm season and should still do after a swarm has cased the property, is specific:
- Soffit vents need mesh smaller than one-fourth inch. Number 8 hardware cloth, at one-eighth inch, is the mesh they recommend as a replacement.
- Foam or caulk the gaps around pipes and conduits. Do not try to seal around the main power lines. That is an electrocution risk; call the utility if bees are using the service entrance or the meter base.
- Close the fireplace flue. Swarms enter from the top of a chimney, and a closed flue keeps them out of the room.
- Cover the hole in a water-meter box. A stone or a piece of tape is sometimes enough. Bees use in-ground meter cases.
- Check sewer and heater vents. That usually means getting on the roof, which is its own hazard. If you are not equipped for the roof, hire someone who is. Do not combine a ladder with leftover bees.
- Repair broken siding. Older houses open more gaps as wood decays and settles.
- Hollow porch columns are often open at the top and bottom. People do not notice until a column is full of comb.
- Take birdhouses down after the birds are done. Bluebird and wood-duck boxes are regular honey bee nesting sites. Check dog houses.
- Hooded gas grills, if the vent holes stay open, are cavities. So are sheds, barns, junk piles, discarded appliances, and an old truck's gas tank if the lid is gone. Mississippi State has documented colonies in those places. (extension.msstate.edu)
University of Georgia's version of the same job is shorter and compatible: caulk knot holes, gaps in siding, and openings around plumbing or wiring. Where the opening has to breathe, cover it with window screen instead of plugging it solid. (fieldreport.caes.uga.edu)
UC IPM adds three rules for the holes that lead into real voids, after bees have been removed and, by the same reasoning, after scouts have been working a wall:
- Seal every opening large enough for a pencil, or larger, that opens into a spacious cavity.
- Screen larger holes with mesh of six or more wires per inch.
- Fill big voids with expandable foam so they are no longer a 9-gallon room.
Bees can chew out through caulk. UC IPM says they will not chew in through it. That difference matters a lot. Caulk is a door that stays shut from the outside. It is not a lid you can clap onto a live colony and forget. The area to inspect is the whole side of the building around the entrance they were using, and both sides if the entrance was on a corner. A void next to the old nest is enough. (ipm.ucanr.edu)
Do not close a hole that still has bees behind it
Penn State states the failure mode without softening it. Never seal a live honey bee colony inside a wall. The bees can chew through drywall and come out in a mass inside the house. Residual comb or honey, if you kill or drive the bees and leave the nest, draws later swarms and other insects. A colony in a wall can mean more than 100 pounds of honey plus the comb and the brood. Taking that out is construction work done by someone who understands both the insects and the building. (extension.psu.edu)
UC IPM describes what happens if a colony is killed in place and the combs stay. Dead bees can rot and smell. Honey takes up moisture, ferments, and the cappings burst. Honey then runs until it hits a fire block, a window frame, or a ceiling and soaks the drywall. If a pesticide was used, the wax, honey, and dead bees are contaminated and have to be handled as hazardous waste. Those products, UC IPM notes, are for licensed pest control operators, not a hardware-store aerosol aimed into a weep hole. Georgia limits who should open a wall at all: Delaplane writes that colonies inside walls should be removed only by a honey bee control specialist licensed through the Georgia Department of Agriculture's Structural Pest Control Commission. Other states license structural pest work differently. Ask the state department of agriculture or the pest-control licensing board before you hire someone who says a general contractor's card covers pesticide use. (ipm.ucanr.edu)
University of Georgia adds the stain problem even without poison. If a colony in a wall dies, the bees are no longer fanning the combs. Wax and honey can melt and streak interior walls. That is one reason "wait and see" is a poor plan once pollen-carrying traffic is established, and a reasonable plan when the cluster is still a ball on a shrub with no comb. (fieldreport.caes.uga.edu)
The first evening and the next week
Foragers sometimes spend the night away from the cluster. UC IPM says that after a colony is removed, those returning bees form a small cluster at the old entrance. They can be vacuumed, or killed with an aerosol labeled for bees and wasps outdoors, used exactly as the label reads. A handful of confused workers the morning after a professional removal is also what Georgia describes: disoriented, low sting risk, gone in a day or so. Neither leftover group means the whole swarm has moved back in. A steady two-way flight, especially with pollen, does. (ipm.ucanr.edu)
If the swarm never found a cavity, it may have started comb in the open. UC IPM says exposed-comb colonies sometimes hang on until fall, or year-round where winters stay warm, until robbers, birds, or weather finish them. Mississippi State sees one or two of these a year near Starkville, often after rain delays the move, and the authors describe one that died in early winter because it could not stay warm. An exposed comb on a limb is already a colony. It is more likely to sting than the cluster that was there yesterday. Do not saw the limb down and walk it to the trash. That is a cutout without the wall, and it belongs to someone with a suit and a plan. (extension.msstate.edu)
Here is a practical order for the week the cluster disappears:
- At dusk or the next morning, look for traffic at gaps, not just for the missing ball of bees. Pollen on the legs upgrades the situation from "they left" to "they live here."
- Check the meter box, porch columns, grill, and birdhouses the same day. Those are cavities you can see without opening a wall.
- If the branch, post, or gutter holds visible wax, clean it, knowing another swarm may still investigate that neighborhood.
- Caulk and screen the empty holes on the list above. Skip any gap that still has bees behind it, and skip the electric service.
- If they are in the structure, hire a remover who will take the comb out and then close the void. Get the scope in writing: bees, comb, and the holes, not a spray-and-leave. Cost and what a cutout includes are covered in Bee cutout and hive removal cost.
Mississippi State suggests repeating a walk around the house weekly through the local peak, which in that state is April and May, because the swarm that left may not be the last one scouting your block. The months those walks matter are in Bee swarm season: when calls spike.
Sources
- Removing Honey Bee Swarms and Established Hives | UC IPM
- Honey Bee Swarms and Bees in Walls | University of Georgia Extension C 824
- Prevention and Treatment of Nuisance Honey Bees Around Your Home | Mississippi State University Extension
- Common Social Bees and Wasps of Pennsylvania | Penn State Extension
- Frequently Asked Questions About Honey Bee Swarms | Clemson HGIC 1736
Free guide 路 PDF
Bee Swarm Quick-Action Card
A printable fridge card: what a swarm is, how to stay safe, and exactly what to tell a beekeeper so they can collect it.
Free. We email you the download link, plus an occasional plain-English guide. Unsubscribe any time. We never sell your email. Privacy